The accurate measurement of suspended sediment (<200 μm) in aquatic environments is essential to understand and effectively manage changes to sediment, nutrient, and contaminant concentrations on both temporal and spatial scales. Commonly used sampling techniques for suspended sediment either lack the ability to accurately measure sediment concentration (e.g., passive sediment samplers) or are too expensive to deploy in sufficient number to provide landscape‐scale information (e.g., automated discrete samplers). Here, we evaluate a time‐integrated suspended sediment sampling technique, the pumped active suspended sediment (PASS) sampler, which collects a sample that can be used for the accurate measurement of time‐weighted average (TWA) suspended sediment concentration and sediment particle size distribution. The sampler was evaluated against an established passive time‐integrated suspended sediment sampling technique (i.e., Phillips sampler) and the standard discrete sampling method (i.e., manual discrete sampling). The PASS sampler collected a sample representative of TWA suspended sediment concentration and particle size distribution of a control sediment under laboratory conditions. Field application of the PASS sampler showed that it collected a representative TWA suspended sediment concentration and particle size distribution during high flow events in an urban stream. The particle size distribution of sediment collected by the PASS and Phillips samplers were comparable and the TWA suspended sediment concentration of the samples collected using the PASS and discrete sampling techniques agreed well, differing by only 4% and 6% for two different high flow events. We should note that the current configuration of the PASS sampler does not provide a flow‐weighted measurement and, therefore, is not suitable for the determination of sediment loads. The PASS sampler is a simple, inexpensive, and robust in situ sampling technique for the accurate measurement of TWA suspended sediment concentration and particle size distribution. 相似文献
For health, economic, and aesthetic reasons, allowable concentrations (as suggested by the United States Environmental Protection Agency) of the secondary contaminants iron (Fe) and manganese (Mn) found present in drinking water are 0.3 and 0.05 mg/L, respectively. Water samples taken from private drinking wells in rural communities within Buncombe County, North Carolina contain concentrations of these metals that exceed secondary water quality criteria. This study predicted the spatial distribution of Fe and Mn in the county, and evaluated the effect of site environmental factors (bedrock geology, ground elevation, saprolite thickness, and drinking water well depth) in controlling the variability of Fe and Mn in groundwater. A statistically significant correlation between Fe and Mn concentrations, attributable to bedrock geology, was identified. Prediction models were created using ordinary kriging and cokriging interpolation techniques to estimate the presence of Fe and Mn in groundwater where direct measurements are not possible. This same procedure can be used to estimate the trend of other contaminants in the groundwater in different areas with similar hydrogeological settings. 相似文献
Understanding the hydrologic connectivity between kettle holes and shallow groundwater, particularly in reaction to the highly variable local meteorological conditions, is of paramount importance for tracing water in a hydro(geo)logically complex landscape and thus for integrated water resource management. This article is aimed at identifying the dominant hydrological processes affecting the kettle holes' water balance and their interactions with the shallow groundwater domain in the Uckermark region, located in the north-east of Germany. For this reason, based on the stable isotopes of oxygen (δ18O ) and hydrogen (δ2H ), an isotopic mass balance model was employed to compute the evaporative loss of water from the kettle holes from February to August 2017. Results demonstrated that shallow groundwater inflow may play the pivotal role in the processes taking part in the hydrology of the kettle holes in the Uckermark region. Based on the calculated evaporation/inflow (E/I) ratios, most of the kettle holes (86.7%) were ascertained to have a partially open, flow-through-dominated system. Moreover, we identified an inverse correlation between E/I ratios and the altitudes of the kettle holes. The same holds for electrical conductivity (EC) and the altitudes of the kettle holes. In accordance with the findings obtained from this study, a conceptual model explaining the interaction between the shallow groundwater and the kettle holes of Uckermark was developed. The model exhibited that across the highest altitudes, the recharge kettle holes are dominant, where a lower ratio of E/I and a lower EC was detected. By contrast, the lowest topographical depressions represent the discharge kettle holes, where a higher ratio of E/I and EC could be identified. The kettle holes existing in between were categorized as flow-through kettle holes through which the recharge takes place from one side and discharge from the other side. 相似文献
Analyses (n = 525) of chloride (Cl−), bromide (Br−), nitrate as nitrogen (NO3-N), sodium (Na+), calcium (Ca2+) and potassium (K+) in stream water, tile-drain water and groundwater were conducted in an urban-agricultural watershed (10% urban/impervious, 87% agriculture) to explore potential differences in the signature of Cl− originating from an urban source as compared with an agricultural source. Only during winter recharge events did measured Cl− concentrations exceed the 230 mg/L chronic threshold. At base flow, nearly all surface water and tile water samples had Cl− concentrations above the calculated background threshold of 18 mg/L. Mann–Whitney U tests revealed ratios of Cl− to Br− (p = .045), to NO3-N (p < .0001), to Ca2+ (p < .0001), and to Na+ (p < .0001) to be significantly different between urban and agricultural waters. While Cl− ratios indicate that road salt was the dominant source of Cl− in the watershed, potassium chloride fertilizer contributed as an important secondary source. Deicing in watersheds where urban land use is minimal had a profound impact on Cl− dynamics; however, agricultural practices contributed Cl− year-round, elevating stream base flow Cl− concentrations above the background level. 相似文献
The Late Pleistocene stratigraphy from the Severnaya Dvina‐Vychegda region of northwestern Russia is revised based on investigations of new localities, revisiting earlier localities, introduction of about 110 new OSL dates and burial depth corrections of earlier published OSL dates, in addition to six new radiocarbon dates. Most of the OSL samples studied here are from fluvial and subaquaeous sediments, which we found to be well bleached. Six chronostratigraphical units and their sedimentary environment are described, with the oldest unit consisting of pre‐Eemian glacial beds. For the first time, Early Weichselian sediments are documented from the region and a fluvial environment with some vegetation and permafrost conditions is suggested to have persisted from the end of the Eemian until at least about 92 ka ago. The period in which a Middle Weichselian White Sea Lake could have existed is constrained to 67?62 ka, but as the lake level never reached the thresholds of the drainage basin, the lake probably existed only for a short interval within this time‐span. Blocking and reversal of fluvial drainage started again around 21?20 ka ago when the Fennoscandian Ice Sheet advanced into the area, reaching its maximum 17?15 ka ago. At that time, an ice‐dammed lake reached its maximum water level, which was around 135 m above present sea level. Drainage of the lake started shortly after 15 ka ago, and the lake was emptied within 700 years. Severe periglacial conditions, with permafrost and aeolian activity, prevailed in the area until about 10.7 ka. 相似文献
Polarised light from astronomical targets can yield a wealth of information about their source radiation mechanisms, and about the geometry of the scattered light regions. Optical observations, of both the linear and circular polarisation components, have been impeded due to non-optimised instrumentation. The need for suitable observing conditions and the availability of luminous targets are also limiting factors. The science motivation of any instrument adds constraints to its operation such as high signal-to-noise (SNR) and detector readout speeds. These factors in particular lead to a wide range of sources that have yet to be observed. The Galway Astronomical Stokes Polarimeter (GASP) has been specifically designed to make observations of these sources. GASP uses division of amplitude polarimeter (DOAP) (Compain and Drevillon Appl. Opt. 37, 5938–5944, 1998) to measure the four components of the Stokes vector (I, Q, U and V) simultaneously, which eliminates the constraints placed upon the need for moving parts during observation, and offers a real-time complete measurement of polarisation. Results from the GASP calibration are presented in this work for both a 1D detector system, and a pixel-by-pixel analysis on a 2D detector system. Following Compain et al. (Appl. Opt. 38, 3490–3502 1999) we use the Eigenvalue Calibration Method (ECM) to measure the polarimetric limitations of the instrument for each of the two systems. Consequently, the ECM is able to compensate for systematic errors introduced by the calibration optics, and it also accounts for all optical elements of the polarimeter in the output. Initial laboratory results of the ECM are presented, using APD detectors, where errors of 0.2 % and 0.1° were measured for the degree of linear polarisation (DOLP) and polarisation angle (PA) respectively. Channel-to-channel image registration is an important aspect of 2-D polarimetry. We present our calibration results of the measured Mueller matrix of each sample, used by the ECM, when 2 Andor iXon Ultra 897 detectors were loaned to the project. A set of Zenith flat-field images were recorded during an observing campaign at the Palomar 200 inch telescope in November 2012. From these we show the polarimetric errors from the spatial polarimetry indicating both the stability and absolute accuracy of GASP. 相似文献
The regions of Central and South America most susceptible to the occurrence of landslides will become even more vulnerable in the context of climate change. The Josefina disaster, in 1993,
demonstrated both the vulnerability of local infrastructures and communities in the Paute River basin (Ecuador). Since this natural phenomena, several landslide inventories and susceptibility studies were developed, revealing the vulnerability of the Paute River basin to unstable terrain and the need for further studies throughout the basin. Despite this, no studies have been done since then to update the information generated. This paper describes a Mobile Application for Regional Landslide Inventories (MARLI), a simple but efficient open-access platform to report landslide events using the Open Data Kit system. Its design makes reporting fast, simple and cost-effective with an added benefit, and a specialized knowledge is not required for its use. MARLI was tested for the collection of landslides in Cuenca (Ecuador). From the data taken in the field, it was possible to analyze the performance and suitability of collected data and compare the results with regional inventories in the same area. Additionally, these results can be used for the elaboration and update of large-scale inventories or the training of automatic identification systems of landslides and later evaluation of their precision in a small-medium scale. Likewise, this product constitutes a fundamental input for the formulation of mitigation strategies, to formulate the appropriate response and in time, also the elaboration of reconstruction plans before the increase in the occurrence of such phenomena.
Mathematical Geosciences - Classical geostatistical methods face serious computational challenges if they are confronted with large spatial datasets. The stochastic local interaction (SLI) approach... 相似文献
The Barmer Basin is a poorly understood rift basin in Rajasthan, northwest India. Exposures in the Sarnoo Hills, situated along the central eastern rift margin of the Barmer Basin, reveal a sedimentary succession that accumulated prior to the main Barmer Basin rift event, and a rift‐oblique fault network that displays unusual geometries and characteristics. Here, we present a comprehensive study of Lower Cretaceous sedimentology on the basin margin, along with a detailed investigation of rift‐oblique faults that are exposed nowhere else in the region and provide critical insights into Barmer Basin evolution. Lower Cretaceous sediments were deposited within a rapidly subsiding alluvial plain fluvial system. Subsequent to deposition, the evolving Sarnoo Hills fault network was affected by structural inheritance during an early, previously unrecognised, rift‐oblique extensional event attributed to transtension between India and Madagascar, and formed a juvenile fault network within the immediate rift‐margin footwall. Ghaggar‐Hakra Formation deposition may have been triggered by early rifting which tectonically destabilised the Marwar Craton prior to the main northeast–southwest Barmer Basin rift event. The identification of early rifting in the Barmer Basin demonstrates that regional extension and the associated rift systems were established throughout northwest India prior to the main phase of Deccan eruptions. Inheritance of early oblique fault systems within the evolving Barmer Basin provides a robust explanation for poorly understood structural complications interpreted in the subsurface throughout the rift. Critically, the presence of syn‐rift sedimentary successions within older oblique rift systems obscured beneath the present‐day Barmer Basin has significant implications for hydrocarbon exploration. 相似文献